Pyralux® TK

INFORMATION & IDEAS

Add filters

DESIGN TIP: Need for Anchoring Spurs and Pad Fillets

DESIGN TIP: Need for Anchoring Spurs and Pad Fillets

During soldering or assembly operations any stress to the conductor/pad interface can cause a fracture of the conductor.

DESIGN TIP: Pad Hold Down Options

DESIGN TIP: Pad Hold Down Options

Design options for covercoated pad hold down for single-sided and double-sided flex circuit applications

DESIGN TIP: Epoxy Resin Fillets

DESIGN TIP: Epoxy Resin Fillets

The purpose of the fillet is to prevent conductors from being cracked when the circuit is flexed during installation.

DESIGN TIP: Balanced Circuit Pattern Reduces Premature Failure

DESIGN TIP: Balanced Circuit Pattern Reduces Premature Failure

Preventing isolated stress conditions critical to ensure no premature falilure will occur in flexibile circuit

DESIGN TIP: Minimum Bend Radius for Flex Circuits

DESIGN TIP: Minimum Bend Radius for Flex Circuits

Even though flex circuits are very pliable and flexible, there are limits to their flexibility.

DuPont Collaborates with Molex on New High Speed Flexible Interconnects

DuPont Collaborates with Molex on New High Speed Flexible Interconnects

Provides system designers with lower loss flexible circuits and interconnects to achieve the desired high speed signal performance required in today’s electronic equipment.

DESIGN TIP: Pad Only Plating

DESIGN TIP: Pad Only Plating

This process is used on double sided (Type 2) circuits where maximum flexibility is desired.

No results founds