The Effluent Quality

WAVE allows the user to specify the desired quality of the produced water. Depending on the IX process the user will be asked to specify:

IX Process

Effluent Quality

Softening

Dealkalization

Demineralization

For Cation resin the effluent quality parameters can be specified in two ways:

Average sodium leakage (this would be the expected average conductivity at the outlet of the anion vessel)
Sodium end point
or
Average conductivity value
Conductivity end point

Note:

Only one of the options above should be specified and the other one will be automatically calculated.

For Anion resin specify the effluent quality parameter as

Mixed Bed

For Cation resin the effluent quality parameters can be specified in two ways:

Average sodium leakage
Sodium end point
or
Average conductivity value (this would be the expected average conductivity at the outlet of the anion vessel)
Conductivity end point

Note:

Only one of the options above should be specified and the other one will be automatically calculated.

For Anion resin specify the following effluent quality parameters

Average silica leakage
Silica end point and
Organics removal efficiency: introduce the expected percentage of organics removal.

Condensate Polishing

For Cation resin the effluent quality parameters can be specified in two ways:

Average NH₄⁺/NH₃ leakage
NH₄⁺/NH₃ end point
or
Average conductivity value (this would be the expected average conductivity at the outlet of the anion vessel)
Conductivity end point

Note:

Only one of the options above should be specified and the other one will be automatically calculated.

For Anion resin specify the effluent quality parameter as

Notes:

Average leakage referes to the expected average leakage during the operation cycle
End point refers to the point when the system will stop operating and start regeneration