Styrofoam™ Brand Ribbed Roofmate™
Insulation that holds the upper hand on heat and cold
Made to reduce the harm of freeze-thaw cycles, Styrofoam™ Brand Roofmate™ XPS Insulation helps maintain a steady temperature in roof membranes – reducing damage during and after construction – and is reusable in many applications.
Styrofoam™ Brand Ribbed Roofmate™
Styrofoam™ Brand Ribbed Roofmate™ Extruded Polystyrene Foam Insulation* is designed for use above waterproofing membrane in protected membrane systems (PMR) that include pavers or patio stones as primary ballast. It helps the roof membrane maintain a steady temperature, minimizing the harmful effects of freezethaw cycles, weathering and physical damage during and after construction.
Features & benefits
| Engineered for use on heavyweight decks |
|
| Rot resistance |
|
Physical Properties
| Method | Unit | Value | |
|---|---|---|---|
| R-value per in., min<sup>1</sup> | - | ft2•h•°F/Btu | 5 |
| Compressive Strength, min.<sup>2</sup> | D1621 | psi (kPa) | 40 |
| Flexural Strength, min.<sup></sup> | C203 | psi (kPa) | 55 |
| Water Absorption, max.<sup></sup> | C272 | % by volume | 0.3 |
| Water Vapor Permeance, max.<sup>3</sup> | E96 | perm (ng/Pa•s•m2) | 1 |
| Coefficient of Linear Thermal Expansion<sup></sup> | D696 | x105in/in °F (x102mm/m °C) | 2 |
| Maximum Use Temperature<sup></sup> | - | °F (°C) | 3.5 (6.3) |
| Flame Spread<sup>5</sup> | E84 | - | 165 (73.8) |
| Smoke Developed<sup></sup> | E84 | - | 15 |
1Values are consistent with the criteria of ASTM C578 and the requirements of the FTC R-value rule (16 CFR Part 460). R means resistance to heat flow. The higher the R-value, the greater the insulating power. Ask your seller for the fact sheet on R-value.
2Vertical compressive strength is measured at 10 percent deformation or at yield, whichever occurs first. Since Styrofoam™ Brand Extruded Polystyrene Foam Insulations are visco-elastic materials, adequate design safety factors should be used to prevent long-term creep and fatigue deformation. For static loads, 3:1 is suggested. For dynamic loads, 10:1 is suggested.
3Water vapor permeance varies with product type and thickness. Values are based on the desiccant method, and they apply to insulation 1" in thickness. Thicker products have lower permeance. Based on 1” thickness.
5This numerical flame spread rating is not intended to reflect hazards presented by this or any other material under actual fire conditions.
Available Sizes
| Width | Length |
|---|---|
| 24 | 96 |
© 2022 DuPont de Nemours, Inc. All rights reserved. DuPont™, the DuPont Oval Logo, and all products, unless otherwise noted, denoted with ™, ℠ or ® are trademarks, service marks or registered trademarks of affiliates of DuPont de Nemours, Inc.