Kapton® RS is an electrically conductive polyimide film
DuPont™ Kapton® RS is an electrically conductive polyimide film developed for applications in which a precisely controlled surface resistivity is needed.
The resistive property is throughout the bulk of the film, so it cannot be cracked, rubbed off or otherwise easily damaged, as is often the case with surface coatings or metallizations.
Applications requiring high temperature performance would benefit from this all-polyimide conductive film. A typical application for this product is flat heaters. As a heater, this material is more efficient since the entire surface area will conduct heat. It can also be easily cut into various configurations. Due to its polyimide composition, it is resilient to high temperature, thin, and highly flexible.
- Consumer Electronics
|Surface Resistivity||ohms/sq||100||Four-point probe|
|Tensile Strength||kpsi||19||ASTM D-882|
|Elogation to break||%||40||ASTM D-882|
For complete information on Kapton® RS, view data sheet.
Product Data Sheets (1)
RELATED DUPONT PRODUCTS & SERVICES
Kapton® corona resistant film withstands the damaging effects of corona discharge. The corona resistance provides improved service life and operational efficiencies versus conventional insulation materials.
DuPont™ Kapton® B polyimide film exhibits an excellent balance of physical, chemical, and electrical properties over a wide temperature range, with superior dimensional stability at elevated temperatures.
Kapton® FCRC combines corona resistant polyimide film with a heat fusible FEP fluoropolymer film. The corona resistance provides improved service life and operational efficiencies vs conventional insulation materials.
DuPont™ Kapton® FN is a general purpose HN film that is coated or laminated on one or both sides with Teflon® FEP fluoropolymer.
Kapton® polyimide film is widely used as a dielectric substrate for its high temperature resistance, self extinguishing burn characteristics, toughness and flexibility.
DuPont™ Kapton® MT polyimide film is a homogeneous film possessing 3x the thermal conductivity and cut through strength of standard Kapton® HN.
Kapton® HN is the recommended choice for applications that require an all-polyimide film with an excellent balance of properties over a wide range of temperatures.
Kapton® GS film has been specifically designed and manufactured to expand the processing window and improve yields during artificial graphite sheet production.
In applications where low shrinkage and superior adhesion are important, Kapton® HPP-ST is the polyimide film of choice.
DuPont™ Kapton® FPC polyimide film is treated on both sides with excellent balance of physical, chemical and electrical properties over a wide temperature range.
Kapton® FCR is a state-of-the-art wire insulation that will withstand corona discharge while delivering improved long term performance, cost effectively.
DuPont Kapton® CR polyimide film was developed specifically to withstand the damaging effects of “corona,” which can cause ionization and eventual breakdown of an insulation material or system when the voltage stress reaches a critical level.