Durable, moisture-resistant DuPont™ Styrofoam™ Brand Cavitymate™ SC Extruded Polystyrene Insulation can help you maximize the performance of your wall assembly. Styrofoam™ Cavitymate™ XPS Insulation is conveniently sized to fit between wall ties.
Styrofoam™ Brand Cavitymate™ SC
DuPont™ Styrofoam™ Brand Cavitymate™ SC Extruded Polystyrene Insulation is a moisture-resistant, curable, lightweight extruded polystyrene (XPS) foam insulation board with square edges on all four sides. Special 16” width makes it easy to fit between brick ties in cavity wall applications. The Styrofoam™ Brand XPS product line gives you the proven thermal and moisture performance of the original XPS, plus the product options you need to design and build energy-efficient, resilient structures all the way to the top. It’s lightweight and easy to install, which makes the work go faster, and it’s readily available through our wide distributor network. When and where you need it, Styrofoam™ Brand is there.
|Lightweight and durable||
|Thermal Resistance per inch (25 mm) @ 75°F (24°C) mean temp.<sup>1</sup>||C518||ft2•h•°F/Btu. R-value, min.||5|
|Compressive Strength<sup>2</sup>||D1621||psi (kPa), min.||15 (110)|
|Flexural Strength<sup></sup>||C203||psi (kPa), min.||-|
|Water Absorption<sup></sup>||C272, D2842||% by volume, max.||0.3, 1.9|
|Water Vapor Permeance<sup>3</sup>||E96||perm (ng/Pa•s•m2 ), max.||1.5 (90)|
|Coefficient of Linear Thermal Expansion<sup></sup>||D696||in/in•°F (mm/m•°C)||3.5 x 10-5 (6.3 x 10-2)|
|Maximum Use Temperature<sup></sup>||-||°F (°C)||165 (74)|
1Values are consistent with the criteria of ASTM C578 and the requirements of the FTC R-value rule (16 CFR Part 460). R means resistance to heat flow. The higher the R-value, the greater the insulating power. Ask your seller for the fact sheet on R-value.
2Vertical compressive strength is measured at 10 percent deformation or at yield, whichever occurs first. Since Styrofoam™ Brand Extruded Polystyrene Foam Insulations are visco-elastic materials, adequate design safety factors should be used to prevent long-term creep and fatigue deformation. For static loads, 3:1 is suggested. For dynamic loads, 10:1 is suggested.
3Based on 1” (25 mm) thickness.